Installing magnetic doorstops is very simple. Here is a step-by-step installation guide:

Required tools and materials:

· Magnetic doorstop set (includes magnet and base plate)
Drill holes using appropriate drill bits.
screwdriver
tape measure

· Level (optional)
pencil or marker
Safety goggles

Steps for installing a magnetic door stop:

 Choose a location:

· Determine the installation location of the magnetic doorstop. Typically, it’s installed on the wall opposite the door or on the baseboard.

Mark location:

· Attach the magnetic plate to the wall or baseboard where you want to install it. Mark the locations of the screw holes with a pencil or marker.

Drilling:

· Drill holes at the marked locations using an electric drill. If drilling holes in drywall, wall anchors may be necessary for added support.

Install the magnetic base plate:
Align the magnetic plate with the drilled hole and secure it with screws. Ensure the magnetic plate is level before fully tightening the screws.

Install the magnet on the door:

· Place the magnet on the door so that it aligns with the magnetic plate when the door is open. Mark the locations of the screws.

· Drill holes in the door, install screws, and securely attach the magnet to the door.

Testing the door stop:
Open the door, ensure the magnets are properly aligned with the base plate, and secure the door in place. Make adjustments if necessary.

Final Adjustments:

· If the door cannot stay open, or the magnet is too strong or too weak, you may need to slightly adjust the position of the magnet or the base plate.

Tip:

· Ensure that the door can be opened freely without obstruction.

· If the door is heavy, make sure the magnetic doorstop is heavy enough to support the weight of the door.

· Always wear safety goggles when drilling to protect your eyes.

By following these steps, you should be able to successfully install the magnetic doorstop.