Adjusting the pivot Hinges of a glass shower door ensures smooth opening and closing and a good seal. 

Here are the detailed steps for adjusting the Pivot Hinges:

Required tools:

Screwdriver (usually a Phillips head screwdriver or a flathead screwdriver, depending on the type of screw)

Allen wrench (if available)

Level (optional)

Measuring tape (optional)

Steps for adjusting the pivot hinges of a glass shower door:

Inspect the door: Before making any adjustments, inspect the door for any visible problems, such as cracks or damage. Ensure the door is clean and free of debris.

Check Alignment: Close the door and see if it aligns with the door frame. Check for gaps at the top and bottom, and ensure the door can swing freely.

Locate the pivot hinges: Locate the pivot hinges, which are usually located at the top and bottom of the door.

Loosen the screws: Using a suitable screwdriver or Allen wrench, slightly loosen the screws on the pivot hinge. Do not remove the screws completely; loosen them only enough to allow for adjustment.

Adjust the car door:

Vertical Adjustment: If the door is too high or too low, you can raise or lower the door by adjusting the top or bottom hinges.

Leveling Adjustment: If the door is not properly aligned, you may need to move it to the left or right. Adjust the screws on the hinges to move the door to the desired position.

Check for levelness: Use a level to ensure the door is straight. Adjust as necessary until the door is level.

Tighten the screws: After adjusting the door to the desired position, carefully tighten the screws on the pivot hinges. Be careful not to overtighten, as this may damage the glass.

Test Door: Open and close the door repeatedly several times to ensure it swings smoothly and seals well. Check for gaps or misalignment.

Final Adjustment: If necessary, make a final adjustment to the hinges until the door functions as expected.

# # Tip:

If the door still does not work properly after adjustment, check the hinges or the door itself for wear or damage.

If you are unsure how to make the adjustment, consider consulting a professional to avoid damaging the glass or hardware.

By following these steps, you should be able to effectively adjust the glass shower door pivot hinges.