Adjusting the pivot Hinges of a glass shower door ensures smooth opening and closing and a good seal.Here are the detailed steps for adjusting the Pivot Hinges:

Required tools:

Screwdriver (usually a Phillips head screwdriver or a flathead screwdriver, depending on the type of screw)

Allen wrench (if available)

Level (optional)

Measuring tape (optional)

Steps for adjusting the pivot hinges of a glass shower door:

Inspect the door: Before making any adjustments, inspect the door for any visible problems, such as cracks or damage. Ensure the door is clean and free of debris.

Check Alignment: Close the door and see if it aligns with the door frame. Check for gaps at the top and bottom, and ensure the door can swing freely.

Locate the pivot hinges: Locate the pivot hinges, which are usually located at the top and bottom of the door.

Loosen the screws: Using a suitable screwdriver or Allen wrench, slightly loosen the screws on the pivot hinge. Do not completely unscrew the screws; loosen them only to the point where adjustment is possible.

Adjust the car door:

Vertical Adjustment: If the door is too high or too low, you can adjust the height by turning the adjusting screw on the pivot hinge. Turning the screw clockwise will usually raise the door, while turning it counterclockwise will lower it.

Horizontal Adjustment: If the door is not properly aligned with the door frame, you may need to adjust its horizontal position. This can usually be achieved by moving the door left or right at the pivot hinge.

Check for levelness: Use a level to ensure the door is straight. Adjust as necessary until the door is level.

Tighten the screws: After making the necessary adjustments, tighten the screws to secure the door in place.

Test Door: Open and close the door several times to ensure it swings smoothly and fits snugly against the frame. Check for gaps or misalignment.

Final Adjustment: If necessary, make any final adjustments to ensure the door functions properly.